All about Photography and Accessories

How to Dry Your Film Film

<p>

Many people who prepare their own movie theater to find the actual drying trickiest part. How to avoid labeling the film …. and get a nice, clean, professional-looking results?

<p>

Get-covered plastic plate of about 2 meters long and screw on the eye at regular intervals. Make a number of S-hooks made of wire, to promote his film perforation. It's good idea to use a set of cones at one end point to be easily and quickly connect to the film.

<p>

The board is suspended or supported from the ceiling in a relatively dust-free room. You may use the hooks on it. Large plastic sheet, about 4.5 meters long, is recorded the back edge of the board. The other end is connected to a piece of doweling. Fit the appropriate size of the two hooks on the front edge of the plate, hang dowels.

<p>

href = "http://2.bp.blogspot.com/_KsrfillTmzs/STmponoY29I/AAAAAAAAAB0/kgtHD4hauMw/s1600-h/film+dryer.jpg">

<p>
You'll also need cards about the same length as the width of the board. Also good sponge simply cut a slit in it with scissors. Oh, and some clothes pegs.

<p>
After processing and thorough washing your film, give a final rinse in distilled water to remove any chalky deposits if you live in a hard water area. Then add a few drops of a wetting agent to provide a spiral of final buzz. Rinse the sponge , and squeezed almost dry. Take the spiral from the developing chamber and connected to the end of the film on the first S-hook. Since the helix is rotated Film should unwind easily. It is always an exciting moment, as you can see frames of the film first, but try to resist for too long look like grains of dust homing in! Working quickly enough, but with great caution. Have clean hands to a chair instead of a spiral (if you three hands). Now, about 2 meters depend film, turn your attention to parasitism. Hold the film near the top of its edges, connect the sponge slot, then gently pull for her. Depend on an additional 2 meters of film and place spiral on the upper deck while you sponge that length. Then very carefully attach the film perforations to the next S-hook. Then in another place a hook to hang from each other and loops nicely.

<p>
Continue like this until the whole film is extracted and hanging in long loops close the floor. Depending on the length of the movie you need to go the same route with more hooks along the playing surface. Always ensure that the sponge is wrung out, and meticulously clean, then it will never scratch the soft film.

<p>
Finally, extract the plastic film loops behind the film, and near the length of the floor space on card to. The bind list and shall not affect the film. Roll out the rest of the worksheet and hang the anchor. Peg sides of the sheet together, but allow considerable space for the passage of air. You have virtually dust-free packaging. Leave film maybe 12 hours, as you are completely dry before it is wound on spools in the project. Hopefully you will find your movie in pristine state, without any dirt or marks. If you still see the strange limestone trade mark which does not harm the film by the way, can be removed with a soft cloth.

<p>
The key to decent results, the absolute purity. If you can not find a room with no dust, try commandeering a bathroom, bath, in fact could be a good place to hang the film and easy to cover.

<p>
And for those who have not tried home-development, it's a fantastic feeling of a film project learned that you did ALL done yourself. !

<p>

For more articles like this visit my blog! <p>

Cam Blog "> www.filmcamblog.blogspot.com

<p>

About the Author:

For more of my photos/articles and such, visit my blog!

or to purchase vintage photographic equipment visit:-

Article Source: ArticlesBase.com – How to Dry Your Movie Film

Cut Film Daylight Developing Tank $38.95 Cut Film Daylight Developing Tank

Utility Developing Tank for Film up to 4×5 $17.95 Floating lid slows oxidation. Snug fitting cover is included for storing chemicals. Holds 12 4×5 film hangers and 1/2 gallon of solution. Also holds roll film on reels for in-dark developing. Made of high-impact plastic.

Universal Developing Tank with 2 Adjustable Reels $24.95 This Universal Developing Tank is designed for the processing of black & white or color film, including reversal films that require a second exposure during processing.